You have no items in your shopping cart.

0

×

Registration

Profile Informations

Login Datas

or login

First name is required!
Last name is required!
First name is not valid!
Last name is not valid!
This is not an email address!
Email address is required!
This email is already registered!
Password is required!
Enter a valid password!
Please enter 6 or more characters!
Please enter 16 or less characters!
Passwords are not same!
Terms and Conditions are required!
Email or Password is wrong!

ZyPer Firmware

Please contact support for the latest Firmware update +1 (877) 493-3833. 

 

ZYPER4K HDMI 2.0 FIRMWARE - REVISION 3.3.2, RELEASED December 11, 2017

Supported platforms: ZyPer4K HDMI2.0 encoders and decoders. NOTE: This update is for the devices with white metal casing only, not black.

Release Notes:

  • Support for Multiview to 1080p displays.
  • Support genlocked scaling to 1080p displays.
  • Support for flash LEDs command.
  • Support for factory defaults command.

 

ZYPER4K HDMI 2.0 FIRMWARE - REVISION 3.2.2, RELEASED May 22, 2017

Supported platforms: ZyPer4K HDMI2.0 encoders and decoders. NOTE: This update is for the devices with white metal casing only, not black.

Release Notes:

  • This update will automatically enable Auto-EDID which is required for Multiview
  • Added support for additional 4K60Hz input formats, output for these formats will be limited to 8-bit RGB
    • Added formats include:
    • 4K60Hz 8-bit 4:2:0
    • 4K60Hz 10-bit 4:2:0 (HDR)
    • 4K60 10-bit 4:2:2
  • Converts YUV 4:2:2 and YUV 4:2:0 source signals to RGB to make these sources available for all processing modes.

 

ZYPER4K FIRMWARE - REVISION 2.11.5, RELEASED February 9, 2017

Supported platforms: All current ZyPer4K encoders and decoders. NOTE: This update is for the devices with black metal casing not white.

Release Notes: Corrects a source address issue which causes audio packets to be dropped in switches that implement a “reverse path forwarding check”. Previous issue where a large audio delay was seen on video joins has been corrected.

This firmware update requires the ZyPer Management Platform to be running Release 1.4 or greater. 

 

ZYPER4K FIRMWARE - REVISION 2.10.5, RELEASED SEPTEMBER 19, 2016

Supported platforms: All current ZyPer4K encoders and decoders

Release Notes: Both 1080i 60Hz and 50Hz resolutions are now supported in Fast-switch mode. Previous firmware versions only supported 1080i in Genlocked mode. Video wall mode still only supports progressive resolutions · Support for Pronto formatted IR codes. A Pronto formatted string may now be injected to an endpoint via the ZyPerMP, and that IR code will be transmitted out the IR port.

Back to Top